ENHANCED FAILURE PREDICTION IN SHEET METAL FORMING SIMULATIONS THROUGH COUPLING OF LS-DYNA AND ALGORITHM CRACH

In sheet-metal-forming the forming limit curve (FLC) is used for ductile sheets to predict fracture in deep drawing. However the use of the FLC is limited to linear strain paths. The initial FLC cannot be used in a complex nonlinear strain history of a deep drawing process or a successive stamp and crash process including a significant change in strain rate. The CRACH software has been developed to predict the forming limit of sheets for nonlinear strain paths [1]. It has been validated to predict instability for bilinear strain paths with static loading in the first path and dynamic loading in the second path for mild steels [2]. As the postprocessing of strain paths from single finite elements in CRACH is not economic for industrial applications MATFEM initiated a project to couple CRACH directly with FEM-Code LS-DYNA using a user- defined material model. This allows a prediction of possible failure during the simulation for all elements with respect to their complete strain history. A special strategy has been developed to include CRACH without extensive increase in total CPU time. The developed interface to LS-DYNA allows also the implementation of other failure criteria demanding the history of deformation like for example a tensorial fracture criterion. In order to test the reliability of the calculated safety factor experimental tests for bilinear strain paths have been simulated [2]. In this case the experimental and numerical investigations have been made on two-stage forming processes (static in the 1st stage and both static/dynamic in the 2nd stage) . The static-static case should simulate a stamping process with bilinear strain path. The static-dynamic case should simulate a successive stamp and crash process. The simulation of a complex deep drawing problem including areas with significantly nonlinear strain paths has been simulated with LS-DYNA/CRACH-coupling. It can be shown that the prediction of CRACH can differ significantely from a “standard” prediction based on the initial FLC. The coupling of LS-DYNA and CRACH showed the potential to predict possible fracture in deep drawing and crash loading at an early design stage and allowed to optimise geometry and material quality to significantly reduce later problems in real components.